Adding An N_Port To A Port Group; Deleting An N_Port From A Port Group; Removing A Port Group; Figure 10 Port Group 1 (Pg1) Setup - HP StoreFabric SN6500B Administrator's Manual

3
Port Grouping policy
FIGURE 10

Adding an N_Port to a port group

1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --pgadd command with the appropriate options to add an N_Port to a specific

Deleting an N_Port from a port group

Before deleting an N_Port, all F_Ports mapped to the N_Port should be remapped before the
N_Port is deleted from a port group.
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --pgdel command with the appropriate options to delete an N_Port from a
3. Enter the ag --pgshow command to verify the N_Port was deleted from the specified port

Removing a port group

1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --pgremove command with the appropriate options to remove a port group. In
42
F_Port1
N_Port1
F_Port2
AG
F_Port3
N_Port2
F_Port4
Port group 1 (PG1) setup
port group. In the following example, N_Port 14 is added to port group 3.
Note that if you add more than one N_Port, you must separate them with a semicolon.
switch:admin> ag --pgadd 3 14
N_Port[s] are added to the port group 3
specific port group. In the following example, N_Port 13 is removed from port group 3.
switch:admin> ag --pgdel 3 13
N_Port[s] are deleted from port group 3
group.
the following example, port group 3 is removed.
switch:admin> ag --pgremove 3
Fabric-1
PG1
Fabric-2
Storage
Array
Access Gateway Administrator's Guide
53-1002743-01