Figure 11 Failover Behavior - HP StoreFabric SN6500B Administrator's Manual

3
Failover policy
Example 1
Hosts
Host_1
Host_2
Host_3
Host_4
Host_5
Host_6
Host_7
Host_8
FIGURE 11
Adding a preferred secondary N_Port (optional)
F_Ports automatically fail over to any available N_Port. Alternatively, you can specify a preferred
secondary N_Port in case the primary N_Port fails. If the primary N_Port goes offline, the F_Ports
fail over to the preferred secondary N_Port (if it is online), then re-enable. If the secondary N_Port is
offline, the F_Ports will disable. Define the preferred secondary N_Ports per F_Port. For example, if
two F_Ports are mapped to a primary N_Port, you can define a secondary N_Port for one of those
F_Ports and not define a secondary N_Port for the other F_Port. F_Ports must have a primary
N_Port mapped before a secondary N_Port can be configured.
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --prefset command with the "F_Port1;F_Port2; ..." N_Port options to add the
NOTE
Preferred mapping is not allowed when Automatic Login Balancing mode is enabled for a port group.
All N_Ports are the same when Automatic Login Balancing mode is enabled.
52
Access Gateway
F_1
F_2
N_1
F_3
N_2
F_4
F_5
N_3
F_6
N_4
F_7
F_8
Failover behavior
preferred secondary F_Ports to the specified N_Port.
The F_Ports must be enclosed in quotation marks and the port numbers must be separated by
a semicolon, as shown in the following example.
switch:admin> ag --prefset "3;9" 4
Preferred N_Port is set successfully for the F_Port[s]
Example 2
Hosts
Host_1
Fabric
Edge Switch
(Switch_A)
Host_2
F_A1
Host_3
F_A2
Host_4
Edge Switch
(Switch_B)
F_B1 Host_5
Host_6
F_B2
Host_7
Host_8
Access Gateway
Fabric
F_1
Edge Switch
(Switch_A)
F_2
F_A1
N_1
F_3
F_A2
N_2
F_4
Edge Switch
(Switch_B)
F_B1
F_5
N_3
F_6 F_B2
N_4
F_7
F_8
Legend
Physical connection
Mapped online
Failover route online
Original mapped route
(offline)
Access Gateway Administrator's Guide
53-1002743-01