Failover With Device Mapping - HP StoreFabric SN6500B Administrator's Manual

Deleting F_Ports from a preferred secondary N_Port
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --prefdel command with the "F_Port1;F_Port2;..." N_Port options to delete

Failover with device mapping

Failover is handled similarly for port mapping and device mapping if devices are mapped to N_Port
groups. If a device is mapped to an N_Port in a group, and an N_Port goes offline, the devices
mapped to that N_Port will reconnect on the least-loaded online N_Ports in the group.
Enabling or disabling the Failover or Failback policies for N_Ports has no effect on device mapping.
A device will always fail over to an online N_Port in the port group, regardless of whether the
Failback policy is enabled for an N_Port or not. Whereas, with port mapping, if you disable the
Failover or Failback policy on an N_Port, the F_Port will not fail over or fail back to other N_Ports.
Failover behavior is different if a device is mapped to a specific N_Port instead of to an N_Port
group. If mapping a device to a specific N_Port, you can define a secondary N_Port that will be
used if the primary N_Port is offline. To maximize the device uptime, it is recommended to map the
device to a port group rather than to specific N_Ports.
Adding a preferred secondary N-Port for device mapping (optional)
Use the following steps to configure a secondary N_Port where devices will connect if their first or
primary N_Port, if defined, is unavailable.
1. Connect to the switch and log in using an account assigned to the admin role.
2. To configure an N_Port as a failover port for one or multiple devices mapped to a specific
Access Gateway Administrator's Guide
53-1002743-01
F_Ports from an N_Port.
The list of F_Ports must be enclosed in quotation marks. Port numbers must be separated by a
semicolon. In the following example, F_Ports 3 and 9 are deleted from preferred secondary
N_Port 4.
switch:admin> ag --prefdel
Preferred N_Port is deleted successfully for the F_Port[s]
N_Port, enter the ag --addwwnfailovermapping N_Port command with the "[WWN];[WWN]"
option. All of the listed device WWNs will use the listed N_Port if it is available and the first
mapped N_Port is unavailable.
The following example configures N_Port 32 as the failover port for two devices already
mapped to a primary N_Port.
ag --addwwnfailovermapping 32
"10:00:00:06:2b:0f:71:0c;10:00:00:05:1e:5e:2c:11"
To configure N_Port 32 as a failover port for all WWNs mapped to the N_Port, enter the ag
--addwwnfailovermapping N_Port command with the --all option.
ag --addwwnfailovermapping 32--all
"3;9" 4
3
Failover policy
53