Command Reference
Network Card Settings
The HP NAS 8000 supports a Network Interface Card (NIC) port on each NAS Server. The
shipped cards are dual-port 10/100 cards, so your NAS really has two NIC ports per server.
When you initially set up your HP NAS 8000, you can specify settings for primary and
secondary NICs using the HP Command View NAS web interface or by using the following
text commands.
getNetworkCardList
Returns list of NIC names and numbers for use in the remaining NIC related commands.
getSystemManagementNetworkCard
Returns the NIC assigned for accessing the Command View NAS web interface.
setSystemManagementNetworkCard
Sets the NIC assigned for accessing the Command View NAS web interface. The default is the
on-board network port (eth0). If you change the port designated as the management port, be
sure to note to new IP configuration as this is only way to re-establish communication with
your NAS server.
getNetworkCardBroadcastAddress
Returns the broadcast address for the specified NIC. The broadcast address is the address that
can be used to send messages to all machines on the subnet.
setNetworkCardBroadcastAddress
Sets the Broadcast address for the specified NIC.
HP StorageWorks NAS 8000 Command Reference
outParam[0:N] = Network card names
outParam[0] = Network card name
inParam[0] = Network card name
inParam[0] = Network card name
outParam[0] = Broadcast address
inParam[0] = Network card name
inParam[1] = Broadcast address
2
19