Table of Contents
Advertisement
Diverting Incoming Calls
If you want to make certain that your incoming calls are
taken care of when you are unable to answer them, you
can use the Call Divert service to divert them to another
phone number.
The Call Divert service lets you:
• divert calls if you are already on the phone.
• divert calls that you do not answer within a
specified time limit (operator dependent).
• divert calls if your phone is turned off or if you are
unreachable
• divert all incoming calls.
You can also use any combination of the above.
The divert option 'All calls' means that all incoming
calls will be diverted to a number specified by you. If
you choose to divert all calls, an arrow (
the display.
Note!
If you activate the 'All calls' divert, all other diverts will
automatically be cancelled. They will, however, be acti-
vated again when you cancel the 'All calls' divert.
Activating a Call Divert
Œ
From the 'Divert' menu, scroll to the required
divert option, using the navigation key. The
options are 'All calls', 'On busy', 'No reply' and
'Unreachable', depending on your operator.
Scroll to the divert option you want, and press
.
YES
Ž
To select 'Activate', press
Press
to enter the menu system. See inside the cover.
l
) is shown in
.
YES
Enter the phone number to which you want your
calls to be diverted, including the area code,
and then press
Note!
If you used the divert option earlier and then cancelled
it, the phone number to which the calls were diverted
will be suggested. Press
number and enter a new one.
There may be a short delay before the network
responds. In the meantime, the message 'Please wait' is
displayed. This is followed by the message 'On busy',
'All calls' or 'No reply' – 'Divert ON', depending on which
divert option you choose. The selected phone number
is also displayed.
The display informs you of any activated call divert
each time you turn the phone on.
Diverting when the Data Menus are On
If you have turned on the 'Data menus', you can set call
diverts for your phone, fax and data numbers
respectively or for all three together. To divert, proceed
as described above.
For the fax and data numbers, there are only two divert
alternatives:
• all calls,
• unanswered.
.
YES
if you want to erase this
CLR
41
Advertisement
Table of Contents
