Nikon COOLPIX AW100 Reference Manual page 74

Ifthe camera fails t ofunction as expected, check the list o fcommon problems
below b efore consulting your retailer orNikon-authorized service representative.
Refer tothe page n umbers inthe right-most column for m ore i nformation.
• See " Error Messages" (_88)formore i nformation.
Power, Displa and Settings Issues
Problem Cause/Solution
Battery is exhausted. 22
Camera has turned off automatically by auto off to save 23
Camera turns off power.
inside of the camera has become hot. Leave the camera
without warning, off until the inside of the camera has cooled.
At low temperatures, the camera and the battery may not _)'- 4
function normally.
Camera is off. 23
Battery is exhausted. 22
Standby mode for saving power: press the power switch, 23
the shutter release button, I_ button, [] button, or •
Monitor is blank. (_ movie record) button.
Camera and computer are connected via USB cable. 73
Camera and TV are connected via A/V cable or HDMI 73
cable.
Monitor is hard to
see.
Date and time of
recording are not
correct.
No information
displayed in
monitor.
Print date not
available.
Date not
appearing on
pictures even
when Print date is
enabled.
Camera settings
reset.
Adjust monitor brightness.
Monitor is dirty, Clean monitor.
if the camera clock has not been set ("Date not set"
indicator blinks during shooting), still pictures have a time
stamp of "00/00/0000 00:00"; and movies are dated "01/
01/2011 00:00." Set the correct date and time using Time
zone and date in the setup menu,
The camera clock is not as accurate as a normal dock,
such as watches, Check camera clock regularly against
more accurate timepieces and reset as required.
Hide info is selected for Photo info under Monitor
settings in the setup menu,
Time zone and date in the setup menu has not been set.
A shooting mode that does not support print date is
selected,
Another function that is set now is restricting the print
date,
The date cannot be imprinted onto a movie,
Clock battery is exhausted; all settings were restored to their
default values.
94
_2
24, 94
94
94
24, 94
94
63
25
-2-