Jenn-Air JCD2295KEP Use & Care Manual page 8

I
NSTALLATION
Handle Extensions
To Install:
• Align and clip handle extension into position on the
handle. Press the extension over the door retainers.
To Remove:
• Slide the extension down and unclip from door
retainer.
Full-Length Aluminum Handles
To Install:
1. Release top door trim (select models)
by removing Phillips screws from top
of fresh food door and retain screws
for later use.
2. Align notches on back of handle
with retaining clips on doors.
Insert clips into notches and
slide handle down until it
contacts bottom trim.
3. Replace top door trim and Phillips
screws.
4. Repeat instructions 1-3 to install
other handle.
To avoid possible injury and damage to property,
tape decorative panels (select models) securely into
place before removing door handles.
7
(select models)
Door Clip
WARNING
To Remove:
1. Release top door trim (select models)
by removing Phillips screws from top
of fresh food door and retain screws
for later use.
2. Grasp handle firmly with both
hands. Slide handle upward
approximately 3 " to release.
⁄
4
3. Repeat instructions 1-2 to
remove other handle.
To Reinstall:
1. Repeat in reverse order.
Euro Handles
This handle style is installed at the factory.
Materials Needed:
• 3 " allen wrench
⁄
32
To Remove:
• Remove set screw from
handle mounting post
using 3 " allen wrench.
⁄
32
• Repeat the procedure on
all posts to remove the
handle.
To Replace:
• Align handle with the mounting posts.
• Fully tighten all set screws to secure handle
in place.