Danby Designer DAC9006DE Use And Care Manual page 4

" _ '_rk"J'_r'_" .! m | |
1. All wiring must comply with local and national
electrical codes and must be installed by a
qualified electrfcian, If you have any questions
regarding the following instructions, contact a
qualified electrician.
2. Check avallable power supply and resolve any
widng problems BEFORE installing and
operating this unit.
3. This 1_5V air conditioner uses 8A or less
(depending on model) nameplate amps and may
be used In any properly wired, general purpose
household receptacle. See Table 1 for
specifications for individual branch circuit.
4. For your safety and protection, this untt Is
grounded through the power cord plug when
plugged Into a matching wall outlet, If
you are not sure whether your wall outlet Is
properly grounded, please consult a
qualified electrician.
5. The wall outlet (3*p!n) must match the plug (3-
pin) on the service cord supplied with the unit,
DO NOT use plug adapters. See Table 2 for
receptacle and fuse tnformatlom tf it is necessary
to use an extensioncord to connect your air
conditioner, use an approved "air conditioner"
extenslon cord only. (available at most local
hardware stores)
6, The rating plate on the unit contains electrical
and other technical data,
Table 1 : Suggested Individual Branch Circuit
Nam_,p(ete Amps AWG Wire Size*
7.3 to 8.4 14
AWG- American Wire Gags
* Based on copper wire at 60 "C temperature rating.
Table 2: Receptacle and Fuse Types
Rated Volts 125
Amps 15
Wall Out}st
Fuse Sfze 15
Time Delay Fuse Plug Type
(or otrcult breaker)