SERVICE AND ADJUSTMENTS
u ,,11,n
TO REPLACE
FUSE (See Fig. 29)
Replace with 30 amp automotive4ype
plug-in fuse, The
fuse holder is located in the engine compartment, directly
in front of the dash,
FUSE
HOLDER
HOOD
HINGE BRACKET
FIG_ 30
LIGHT
CONNECTOR
HOOD SPRING
FIG. 29
TO REPLACE
HEADLIGHT
BULB
•
Raise hood.
•
Pull bulb holder out of the hole in the backside of the
grill
•
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the gal!!,
•
Close hood.
INTERLOCKS
AND
RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running or prevent it from starting
•
Check wiring. See electrical wiring diagram in Repair
Parts section of this manual.
TO REMOVE
HOOD,
GRILL
AND SIDE PAN-
ELS (See Fig's,
30 and 31)
•
Raise hOOdr
•
Unsnap headlight wire connector.
,
Stand at side of tractor.
Grasp hood and tilt forward
and lift off hinge brackets.
•
To reinstall,slide
hood pivot rod into slot in hinge
brackets, and carefully reinstall hood springs.
HOOD PIVOT ROD
HINGE BRACKET
SLOT
FIG. 31
23