The operation of any tractor can result in foreign objects thrown into the eyes, which can
result in severe eye damage
Always wear safety glasses or eye shields while operating
your tractor or performing any adjustments
or repairs
We recommend
wide vision safety
mask for over the spectacles
or standard
safety glasses, available
at Sears Retail or
Catalog stores
HOW TO USE YOUR TRACTOR
TO SET PARKING
BRAKE
(See Fig 7)
•
Depress clutch/brake pedal into full 'BRAKE" position
and hold
•
Place parking brake lever in "ENGAGED" position and
release pressurefrom clutch/brake pedal Pedal should
remain in "BRAKE" position
Make sure parking brake
will hold vehicle secure
STOPPING
(See Fig. 7)
MOWER BLADES
•
Move attachment clutch lever to 'DISENGAGED'
po-
sition
GROUND DRIVE
•
Depress clutch/brake pedal into full BRAKE" position
•
Move gearshift
lever to NEUTRAL"
position
ENGINE -
•
Move throttle control to SLOW'
position
•
Turn ignition key to 'OFF'
position and remove key
Always remove key when leaving vehicle to prevent
unauthorized use
•
Never use choke to stop engine
TO USE THROTTLE
CONTROL
(See Fig. 7)
Always operate engine at full throttle
•
Operating engine at less than full throttle reduces the
battery charging rate and the engine cooling air flow
•
Full throttle offers the best bagging and mower per
formance
TO MOVE FORWARD
AND BACKWARD
(See
Fig. 6)
The direction and speed of movement
is controlled by the
gearshift
lever
.
Start tractor with clutch/brake
pedal depressed and
gearshift [ever in 'NEUTRAL"
position
.
Move gearshift
lever to desired
position
•
Slowly release clutch/brake pedal to start movement
IMPORTANT:
BRING TRACTOR TO A COMPLETE STOP
BEFORE SHIFTING OR CHANGING
GEARS. FAILURE
TO DO SO WILL SHORTEN THE USEFUL LIFE OF YOUR
TRANSAXLE
IGNITION
ATTACHMENT
CLUTCH LEVER
"ENGAGED"
POSITION
THROTTLE/
CHOKE
CONTROL
LEVER
'DISENGAGED"
POSITION
"ENGAGED"
POSITION
POSITION
3EAR
"BRAKE"
SHIFT
POSITION
PEDAL "DRIVE"
LEVER
POSITION
"CLUTCH"
POSITION
FIG, 7
TO ADJUST
MOWER
CUTTING
HEIGHT
(See
Fig. 6)
The position of the attachment
lift lever determines
the
cutting height
•
Grasp lift lever
.
Press plunger with thumb and move lever to desired
position
The cutting height range is approximately
1-1/4 to 3-3/4"
The heights are measured from the ground to the blade tip
with the engine not running
These heights are approxi
mate and may vary depending upon soil conditions, height
of grass and types of grass being mowed
•
The average lawn should be cut approximately
2-t/2
inches d uring the coot season and over 3 inches during
hot months
For healthier and better looking lawns
mow often and after moderate growth
•
For best cutting performance, grass over 6 inches in
height should be mowed twice
Make the first cut
relatively high; the second to desired height
11