Separate Choke Type; Throttle Cable Installation, Adjustment; Choke Cable Installation, Adjustment - Cub Cadet RZT 50 Operator's Manual

24 ADJUSTMENT
Separate choke type
Throttle Cable Installation, Adjustment
• Link the throttle cable (G) to the speed control
lever (C) and loosely clamp the throttle cable outer
housing (F)with the cable clamp bolt (A).
• Move the throttle lever to =FAST" position.
• Pull up the outer housing (F) of the throffie cable
until the inaer wire (G) has almost no slack, and
tighten the cable clamp bolt (A).
• Move the throttle lever to =slowJ position. Make
sure that the carburetor throttle valve (H) is moved
Choke Cable Installation, Adjustment
, Linkthe chokecable (K) to the choke controllever
(D), and loosely clamp the choke cable outer
housing(L) with the cable damp bolt (B).
e Move the equipmentchoke control to "OPEN" po*
sition. Make sure that the carburetor choke vahte
(M) is fullyopened.
e Pull up the outer housing(L) of the choke cable
until the inner wire (K) has almost no slack, and
tighten the cable clamp bo_ (B).
• Move the equipmentchoke controlto "CHOKE"
Make sure that the carburetor choke
valve (M) is completely closed.
• Make sure that the choke valve _ms from fully
closed positionto fully opened positionwhen ac-
tuatingMe equipment choke control.
H. ThrottleValve
M. ChokeValve
ADJUSTMENT 25
®
RH_I4 I¥OBIF4 G
43