Table of Contents
Advertisement
Thisscroll s awis designed t ocutwood, w ood compo-
sition products, plastic, andnonferrous metals (alumi-
num,brass, c opper).
GENERAL
OPERATION
Please read and understand the following items
concerning your scroll sew before attempting to use
the sew.
•
There is a learning curve for each person who
wants to use this sew. Dudng that pedod of time
it is expected that some blades will break until
you learn how to use and adjust the sew.
•
Allow the saw to cut material by guiding the
workpiece into the blade as it moves. Do not
force the work.
•
The blade teeth cut matedal only on the down
stroke.
You must guide the workpiece into the blade
slowly because the teeth of the blade are very
small and can only remove matedal on the down
stroke.
•
Scroll saw blades wear out and must be replaced
frequently for best cutting results. Scroll saw
blades generally stay sharp for 112 hour to 2
hours of cutting, depending on type of material
and speed of operation.
•
To get accurate cuts, be prepared to compen-
sate for the blade's tendency to follow the wood
grain as you are cutting wood.
•
In cutting wood, best results are achieved when
cutting wood less than one inch thick.
•
When cutting wood thicker than one inch, the
user must guide the workpiece very slowly into
the blade and take extra care not to bend or twist
the blade while cutting.
•
When choosing a blade to use with your scroll
sew, consider the following carefully:
• Very fine, narrow blades should be used to
scroll cut in thin matedal 1/4 in. thick or less.
Most blade packages state the size or thick-
ness and type of material which that blade is
intended to cut. Package should also state the
radius, or size of curve, which can be cut with
that blade.
• Wider blades cannot cut curves as tight or
small as thinner blades.
•
Blades wear faster:
• When cutting plywood and other laminates.
• When cutting matedal thicker than 3/4 in.
• When cutting hardwood.
• When side pressure is applied to the blade.
ON/OFF
KNOB
WITH
VARIABLE
SPEED
See Figure 16.
Your scroll saw has an easy access On/Off knob with
variable speed.
•
Pull the knob out to turn ON the saw, and push
the knob in to turn OFF the sew.
Note: After saw is turned on, a hesitation before
blade movement is normal.
WARNING:
Never leave the saw unattended
until the blade has come to a complete stop to
prevent serious personal injury.
POST
ON/OFFKNOB
Fig. 16
•
By turning the knob, the variable speed control
may be adjusted from the high speed of approxi-
mately 1700 SPM (Strokes Per Minute) to the
low speed of approximately 500 SPM. Suggested
speeds are identified under Choice of Blade and
Speed, page 18. Turn the On/Off knob to the
right or clockwise to increase strokes per minute
and to the left or counterclockwiseto reduce the
strokes per minute.
This motor has an electronic control that regulates the
speed and provides ovedoad protection to the motor.
If the motor fails to start after about 2 seconds, push
the knob OFF and disconnect the saw from the power
source. Refer to the troubleshooting chart.
Note: I1the internal overload protector has been
tripped, pushing the On/Off knob OFF will reset it.
16
Hide quick links:
Advertisement
Table of Contents
