GE J2S968 Owner's Manual page 13

Usingthe clock, timer and control lockout, vvvvw.GEAppliances.co
Make sure the clock is set to the
correct time of da,A
ToSet the Clock
The clock must be set to tile correct time
of dm fin" tile automatic o',en tinting
flmctions to work properl). Tile time of
da) cannot be changed dining a timed
baking or self=cleaning cycle,
[] Touch tile
CLOCK pad.
[] Touch tile number pads.
[] Touch the START pad.
[]
The timer is a mflTutetimer onl_
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59mhTutes.
ToSet the Timer
[]
Touch
tile KITCHEN TIMER
ON/OFF pad.
Touch tile nmnber pads tmfil tile
aiilOtlnt of time yell want shows
in tile displa): For example, to set
2 hom_ and 45 minutes,
much 2, 4
and 5 in that order: If you make a
mistake
touch tile KITCHEN TIMER
ON/OFF pad and begin again.
Touch tile STARTpad.
After touching the STARTpad, SET disappears,
this tells you the tl_neis counting down,although
the display doesnot changeuntil one minute has
passed Seconds wi// not be shown in the display
until the/astmlnute is counting down.
[] _hen tile timer reaches :00, tile
control will beep 3 times followed
by one beep eve_ T 6 seconds tmtil
tile KITCHENTIMERON/OFF
pad
is touched.
The&second tone can be cance/edby fo//owlbg
the steps in the Special features of your oven
control section under Tones at the Endof a
TimedCycle.
To Reset the Timer
If tile display is st.ill shoMng tile time
remaining, you may change it by
touching tile KITCHEN TIMER ON/OFF pad,
then touch tile number pads tmtil tile
time w_u want appea_ in tile displa>
If tile remaining time is not in tile display
(clock, delay start or cooking time are in
tile display), recall tile remaining time by
touching tile KITCHEN TIMER ON/OFF pad
and then touching tile ntllllber pads to
enter tile new tillle vi)[i iV_lllt,
ToCancel the Timer
Touch tile KITCHEN TIMER ON/OFF
pad twice.
LOCK/UNLOCK HOLD 3 SECONDS
Control Lockout
Yourcontrol will allow you to lock out the touch
pads so they cannot be activated when pressed
To lock/ mflock tile controls:
[] Touch the 9 and 0pads at tile same
time fin 3 seconds, tmtil tile displa)
sho_vs LOC ON.
[] To unlock tile control, touch tile 9
and 0pads at tile same time fin" 3
seconds, until tile display shows
LOC OFF.
When this teatm'e is on and tile touch
pads are touched, tile control will beep
and tile display will show LOC ON.
Thecontrol/ockoutmode affects a// touch
pads. No touch pads wi// work when this
feature is activated
Theadjustment will be retained in memory
after a power fai/ure.
13