Kenmore ULTRA WASH 665.13485 Use & Care Manual page 11

Suggested 10 place setting loading patterns
Knife holder (on some models)
Use the knife holder on the left side of the bottom rack to
hold knives that are too large for the silverware basket.
Place knives in the holder as shown.
TURBOZONE
TM
10 place setting top rack load
! j
TURBOZONE
TM
10place setting bottom rack load
Fold-down tines
You can fold down one row of tines at the back of the
bottom rack.
To remove the knife holder
1. Slide up to release the hooks over the rack wire.
2. Lift knife holder out of rack.
To install the knife holder
1. Align the knife holder with the bottom rack as shown in
the illustration below.
2. Place the bottom slotted guide over the vertical wire in
the side of the rack.
3. Place the hooks, located on the back of the knife
holder, over the center rack wire and gently push down
to lock into place.
1. Grasp the tip of the tine that is in the tine holder.
2. Gently pull the tine out of the tine holder.
3. Lay the row of tines down in the rack to make room for
larger dishes, bowls, pots, pans or roasters.
NOTE: When using the TURBOZONE
TM
option, position
the rear fold down tines in the 60 ° location for best
performance.
A. Top alignment
B. Bottom slotted guide
C. Knife holder hooks
11