Sharp AR-NS1 Operation Manual page 9

5
This page lets the system administrator select passwords for the entire web site (refer to the
following Table). Key in a user password in the User Access to Destination List field and/or an
administrator password in the Admin Control for E-mail/Scanning field.
One password for each User and Admin respectively can be registered. After entering the passwords in
both the entry and confirm locations for User and Admin, check the box of Enable Password Protection of
this Web Site and click the Submit button to register the passwords.
If you enable the password protection with entering neither User nor Admin password, the password
"Sharp" will automatically be entered.
NOTES
1. Password input is case sensitive (lowercase and uppercase characters are distinguished).
2. Both passwords need to be entered prior to submitting. If only one password is entered and confirmed
the other will default to "Sharp" after submitting.
3. The passwords must be confirmed by entering in both fields of "User Access to Destination List" and
"Confirm Password" for the user password and "Admin Control for E-mail/Scanning" and "Confirm
Password" for the administrator password, and then select the Submit button to register the passwords.
Once the passwords have been registered, you will be prompted for user name and password
every time you try to enter the web pages of the network scanning system. The user names will
always be "user" for user level and "admin" for administrator level.
Name
Enable
Protection of this Web Site
User Access
Destination List
Confirm Password
Admin Control
mail/Scanning
Confirm Password
Definition
Password To enable password protection, check the box and click
the Submit button. To disable it, clear the check mark in
the box and click the Submit button.
to Enter a User password within 10 characters.
Enter the User password again to confirm it.
for E- Enter an Admin password within 10 characters.
Enter the Admin password again to confirm it.
5
Chapter 2 Getting Started