Sharp CD-MPX870 Operation Manual page 33

To perform programmed recording:
1 Program discs and tracks (see page 22).
2 Press the button.
3 Press the / (TAPE ) button to start recording.
To stop recording:
Press the (TAPE ) button.
The disc and tape will stop.
Recording from the radio
1
Tune in to the desired station (see page 27).
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button.
Recording will be paused.
4
Press the / (TAPE ) button to start recording.
To interrupt recording:
Press the button.
To resume recording, press the / (TAPE
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise while recording an AM station, move the
AM loop antenna.
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a prerecorded cassette
into the TAPE 1 cassette com-
partment. Insert a blank tape
into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
3
Press the TAPE (1
the display.
4
Press the
Recording will be paused.
5
Press the
To stop dubbing:
Press the (TAPE ) button.
) button.
TAPE 1 and TAPE 2 will stop simultaneously.
Erasing recorded tapes
1 Load the tape to be erased into the TAPE 2 cassette compart-
ment with the side to be erased facing toward you.
2 Press the TAPE (1
play.
3 Press the
4 Press the
Note:
Make sure that the TAPE 1 is not in use.
03/12/19
TAPE 1 TAPE 2
2) button until "TAPE 1" appears on
button.
/ (TAPE ) button to start dubbing.
2) button until "TAPE 2" appears on the dis-
button.
/ (TAPE ) button to start erasing.
CD-MPX870 25-32.fm
CD-MPX870
CD-MPX870W
ENGLISH
E-32