Basic Operation - Sharp AY-XPM12FR Operation Manual

BASIC OPERATION

DISPLAY
MODE 1h
CLEAN
FAN
SWING
SET/C
NOTES:
This air conditioner is a multi-type, and multiple indoor units are connected to one outdoor unit.
When the setting mode differs among indoor unit(s), the indoor unit(s) operated later may not work.
• When the indoor unit(s) is/are operating in HEAT mode, the remaining unit(s) can not operate in
COOL or DRY mode.
• When the indoor unit(s) is/are operating in COOL or DRY mode, the remaining unit(s) can not
operate in HEAT mode.
When the mode of the indoor unit(s) later operated is/are different from those which is/are in
operation, after a few seconds, a long BEEP will be emitted and the temperature indicator on the
indicator panel will indicate"
This shows that the later operated unit(s) is/are not working. In such case, change the remote
control's mode and send the same mode signal which the other indoor unit(s) is/are operating in.
Press the MODE button to select the op-
1
eration mode.
Press the ON/OFF button to start opera-
2
tion.
• The red OPERATION lamp (
will light.
2
Press the THERMOSTAT button to set the
3
5
desired temperature.
AUTO/DRY MODE
3
• The temperature can
be changed in 1°C in-
crements within the
1
range of 2°C higher to
2°C lower from the
temperature automati-
cally determined by
4
the air conditioner.
COOL/HEAT MODE
• The temperature can be set within the range
of 18 to 32°C.
Press the FAN button to set the desired fan
4
speed.
• In the DRY mode, the fan speed is preset to
AUTO and cannot be changed.
To turn off the unit, press the ON/OFF but-
5
ton again.
• The red OPERATION lamp (
will turn off.
" and the OPERATION lamp and TIMER lamp will blink alternately.
E-8
AUTO HEAT COOL
(Example: 1°C higher)
(Example: 2°C lower)
AUTO SOFT LOW
DRY
) on the unit
C
C
HIGH
) on the unit