Pre-Installation Considerations; Component Mounting - Scytek electronic Astra 50 Installation & Operating Instructions Manual

PRE- INSTALLATION CONSIDERATIONS
To ease installation, we suggest that you READ THIS MANUAL before beginning your installation.
BEFORE BEGINNING , check all vehicle manufacturer cautions and warnings regarding electrical service
(AIR BAGS, ABS BRAKES, ENGINE / BODY COMPUTER AND BATTERY).
PLAN OUT YOUR INSTALLATION and determine most suitable locations for all components to be
placed.
These components include: the module itself, valet/ program button and possible relays. Allow enough
wire to create a service loop with strain relief, should servicing be required.
DAMAGE resulting from incorrect installation or failure to follow guidelines stated in this book will not be
covered under warranty and subject to repair or replacement charges.
USE A VOLT/ OHM METER to test and locate all connections. Test Lights can damage a vehicle's
computer systems.
ADDITIONAL PARTS , which are not included with this unit, may be needed for your particular vehicle. .
These items may include extra relays or Special "Data Bus" interface modules.
DO NOT ROUTE ANY WIRING THAT MAY BECOME ENTANGLED with brake, and gas pedals,
steering column, or any other moving parts in the vehicle.
REMOVE MAIN SYSTEM FUSE (S) before jump starting the vehicle or charging the vehicles battery.

COMPONENT MOUNTING

CONTROL MODULE: Locate the module underdash as high as possible. Driver's Side usually provides
an easy location for the majority of the wiring connections. The antenna wire should be routed away from
any metal if possible. DO NOT alter the length of the antenna wire, or ground the antenna wire.
OVERRIDE / PROGRAM BUTTON: Mount the button in a hidden but accessible location. It is used for
emergency- disarm (when optional starter disable is installed) without the use of the transmitter and for
programming features of this unit.
LED : The optional Red LED provides a useful theft deterrent. The LED blinks after you lock the vehicle
with your remote simulating an alarm system. The LED is also required when programming options.
Choose a visible location in the dash or console for the LED's location.
WIRING
WHITE WIRE: +12V or (-) NEGATIVE PARKING LIGHT (Jumper Selectable On- Board Relay 10A)
Connect to switched +12V parking light wire at back of light switch. If this is not possible, connect directly
to one of the parking lights at the front of the vehicle. If your vehicle requires a (-) Negative Ground signal
to activate the parking lights, then you have to open the control and move the jumper located on the
circuit board inside the unit. For European vehicles with separate right and left circuits, use a dual relay or
2 diodes to separate the output signal. The DEFAULT output is POSITIVE.
BLACK/ YELLOW WIRE: (-) AUXILIARY REMOTE OUTPUT 3 (Optional, requires relay)
This wire provides a Negative output for activation of optional or auxiliary devices. It is controlled by
Pressing and Holding Buttons (2) Unlock and (4) Panic together.
BLACK/ WHITE WIRE: (-) NEG. or +12V DOME LIGHT (Jumper Selectable On- Board Relay- 10A)
2