Saving Camera Files In The Macintosh; Saving Data Using The Save Buttons - Ricoh Caplio Gate for Macintosh Operation Manual

Saving Camera Files in the Macintosh

You can save image, voice memo and motion picture files
recorded with the camera in a specified folder in the Macintosh.
Check that the camera is properly connected to the Macintosh
before proceeding.
Important
• You cannot select each file saved in the camera.
• To avoid the names of saved files being overwritten, consecutive file
names are assigned and the files are saved in the specified folder. If,
however, the number exceeds 9999, an error message will be
displayed.
• If the power cuts out during operation, the camera or the Macintosh
may be adversely affected. Whenever possible, use the AC adapter
and avoid powering the camera by the battery.
• Do not connect or disconnect the AC adapter or USB cable when
the camera is turned on or data is being transmitted.

Saving Data Using the Save Buttons

You can save files in the camera into the Macintosh using the
RICOH Gate Save buttons.
Data is saved in accordance with the settings registered on the
Save buttons.
m m m m See "Changing the Save Button Settings" (p.26).
Note
• If you save files using the Save 1 or Save 2 button with the status
the same as when RICOH Gate was installed, the files in the camera
will be saved in the following settings.
<Still Image Format>
Still images will be saved in the same format as when they were
recorded.
<Image Size>
Images will be saved in the same size as when they were
recorded.
You can change the setting of the Save buttons if necessary.
m m m m See "Changing the Save Button Settings" (p.26).
1
Check that the camera is properly
connected to the Macintosh.
m m m m See "Connecting the RICOH BASE to a Macintosh"
(p.17).
See "Connecting the Camera to a Macintosh" (p.19).
(Camera ➝ Macintosh)
3
25