Danby DAC5130 Use And Care Manual page 10

6_
SELECTOR Switch Function
The setectoi" swttch controls fan speed and/or
coottng speed, To set desired cooling
temperature, slmply rotate the SELECTOR
kno b to the appropriate setting.
LOW FAN will circulate air at minimum speed
without cooling,
HIGH FAN will circulate air at maximum speed
without cooling.
LOW COOL provides cooling with minimum air
circulation. Recommended for night-time use,
HIGH COOL provides cooling with maximum
air circulation, Recommended for quick cooling
or for extremely hot days. Once room is
cooled, reduce setting to LOW COOL,
NOTE; Always allow 3 minutes before
switching from one mode to another,
OFF shuts-down the unit €ompletely_
THERMOSTAT
The thermostat automatically controls the
(compressor) cooling cycle and maintains the
selected room temperature. To set the
thermostat, rotate the thermostat knob to the
desired cooting setting (t warmest _ 9 coldest),,
The fan motor wil! continue to operate after the
compressor (cooEing) has cycled off. Thts Is
normal.
= Q _-" Selector Swltch
___ Thermostat
When using FAN control, turnselectorswitch
slowly allowing unit to adjust.
When usingTHERMOSTAT, be sure to allow
threeminutes before changingtemperature,
Adjusting too quickly may cause an overload
resulting in a blown fuse,.