Power Indicator Lights Red - Epson EMP-280 User Manual

Problem Solving
t Power indicator lights red
f
Status Cause
Internal Error
Red
Red
Red
Fan Error
Red
Sensor Error
Red
High Temp Error
Red
(overheating)
Red
Problem
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Epson Projector Contact List.
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest
address provided in the Epson Projector Contact List.
The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector
switches to standby mode, so check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s p.48,
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the Epson Projector Contact List.
sEpson Projector Contact List
When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". s
Remedy or Status
sEpson Projector Contact List
sEpson Projector Contact List
56
p.29
35
: Lit : Flashing: : Off