Power Indicator Lights Red - Epson EMP 6110 User Manual

Problem Solving
t Power indicator lights red
f
Status
Internal Error
Red Red Red
Fan Error
Red Red
Sensor Error
High Temp Error
Red Red
(overheating)
Abnormal
Cause
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the
nearest address provided in the Support and Service Guide. s
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the
nearest address provided in the Support and Service Guide. s
The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the
projector switches to standby mode, so check the following two points.
• Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it. s p.58,
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide.
Epson Projector Contact List
s
When using at an altitude of 1500 m or more, set "High Altitude Mode" to "On". s
Note that when the projector is used at altitudes in excess of 1500 m with the smoke filter attached, an internal High
Temp error may occur repeatedly depending on the ambient temperature. Should this occur, set the "Brightness
Control" to "Low". s
If the High Temp errors continue to occur, replace the smoke filter with a new one.
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the Support and Service Guide.
Epson Projector Contact List
s
Remedy or Status
65
p.33
: Lit : Flashing:
Epson Projector Contact List
Epson Projector Contact List
p.35
45
: Off