Table of Contents
Advertisement
REMOTE
CONTROL
MODEL
LR4455
PREPARATION
FOR
USE
Batteries are provided with this remote, but you must Lnstall
them before using the remote.
BATTERY
REPLACEMENT
Your remote comes with batteries installed. When its et'fec-
tivc operating range becomes noticeably shorter, replace
d_e batteries with two high-quality, alkaline, _
A.AA bat-
teries.
NOTE: When the remote does not receive power from its
batteries, it may set itself to Z_nith video equipment
(TV,
Z.¢aith VCR, and Zenith cable-TV decoder) dehult codes.
If you hav_ "taught" it to operate other equipment, it will
forget what it was taught.
To d¢crcas¢this possibility,replace the batteriespromptly,
zmd do not remove the old batteries until you are ready to
insert new ones. The batteries normally have enough power
to save the information
even if they do not haw enough
power to operate the remote.
,
2.
Remove
the battery
compartment
cover.
PUSH
DOWN
tab and PULL
OUT
from top.
Insert
new batteries
a., indicated
by the diagram
inside
the compartmerLt.
Be careful
to place
the
batteries
correctly.
If the polarities
(the + and -)
are reversed,
irreparable
damage
to the remote
control
can occur.
3. Replace the cover by i:aserting the l_abon the bot-
tom of the cover into its housing. Snap the cover
into place.
NOTES:
•
Be careful not to place he_wyobjects on top of the remote
control buttons. Proloag,-d accidental operation of the
remote control will shone+.n battery life.
•
If you will not use the remote control for a mouth or more,
remove the batteries. Battery leakage cancause damage
to the remote control.
•
Zenith is not responsible
for damage causexl by battery
leakage.
1.
e
e
_-o
6-5
Advertisement
Table of Contents
