Step 2. Connect The Power; Step 3. Turn Tv On; Step 4. Use Auto Search; Step 5. Use Other Options - Zenith SENTRY 2 Operating Manual & Warranty

THE FIRST TIME YOU OPERATE YOUR TV
STEP 2. CONNECT THE POWER
Plug your TV into an tmswitched AC power source. ]]]
The switched AC outlets found on some video equipment
will not continue supplying power to the TV once the equip-
ment is turned off. If the power to the TV is interrupted,
you will have to set the clock in the TV to the current time.
w
Do not plug 'IV into switched outlet on cable-TV decoder
Do not plug TV into switched outlet on a VCR
STEP 3. TURN TV ON
Turn the TV on by pressing OFF/ON on the front panel of
the TV or on the remote control.
STEP 4. USE AUTO SEARCH
When your TV is first powered up you will see the AUTO
SEARCH reminder display. AUTO SEARCH finds all
available channels and stores them in memory for access by
CHANNEL (CH) Up/Down. To activate AUTO
SEARCH, press ADJUST (ADJ) Left fRight. When the
search is complete, you can watch the TV program of your
choice.
NOTES:
1. The AUTO SEARCH reminder display appears
each time you turn oll your TV until it has been used
at least once.
2. Antenna or cable mast be connected to TV before
you use AUTO SEARCH.
AUTO SEARCH
PRESS ADJUST
KEY TO START
J
Auto Search
Reminder Display
AUTO SEARCH
SEARCHING .....
While Searching for
Active Channels
CH 2
When Search is
Complete
J
STEP 5. USE OTHER OPTIONS
You may want to consider using the following hook-up and
set-up options:
• Program FAV. (Favorite) CHANNELS to customize the
channels accessed by using CHANNEL (CH) Up/Down.
Refer to the FAV. (Favorite) CHANNELS option of the
"Setup Menu" section of this operating guide for details.
• Set the clock in the TV. Refer to the TIME SET option of
the "Setup Menu" section of this operating guide for
details.
248%A 1 -- 3