Getting To Know Your Remote Control; Introduction; Choosing Operating Mode - Zenith SENTRY 2 Operating Manual & Warranty

GETTING TO KNOW YOUR REMOTE CONTROL
INTRODUCTION
The multi-brand remote control supplied with your new
Zenith TV allows you to operate most models of infra-red
(IR) remote-controlled TVs, VCRs, and cable-TV
decoders, even if they are all different brands. In this way, it
takes the place of the several remote controls previously
needed.
Your multi-brand remote h_ks already been programmed to
operate your new Zenith 'IAt, a Zenith maaufactured cable-
TV decoder and a Zenith VHS VCR. It must be
programmed to operate other brands of equipment.
The following instructions are for operatic,n of Zenith
equipment. The instructions for using thia remote with
non-Zenith equipment are in the section entitled "Program.
ming the Remote Control".
CHOOSING OPERATING MODE
To use the remote to operate your TV, a cable-TV decoder
or a VCR, you must fast choose the mode of operation of
the remote control. To select the TV, CABLE or VCR
mode of operation, press MODE repeatedly until the cor-
responding, indicator lights.
Some controls on the remote, like PLAY and VOLUME,
will always operate the VCK or the TV. Whether other keys
operate the TV or the VCR depends on which mode of
operation the remote control is in. For example, OFF-ON
will turn the; VCR on and off while the remote control is in
the VCR mode. It will turn the TV on or off while the
remote control is in TV mode.
Operating MODE switch
and indicators
Menu operations on TV
and some VCRs
Numbered buttons for
channel selection and
other uses
NOTE: See following pages
for operating instructions.
r-if-1 r-_-i
SELECT
QUIT
©®®
®®®
®®®
O0 0
A B
_ F_
OFF
0
0
I_,..A._',OK
Fa
CHANNEL
VOLUME
C:D
C:D
C:D
_.AR'CH
"W._CCR
1
MBR3420
m
t-
t-
Controlled device OFF/ON
Special features on TV and
,;ome VCRs
Channel Up/Down ffw TVs,
VCRs and cable
Volume Up/Do_n for TV
Special features on some
TVs and some VCRs
2s99-o 3 -- 1