HP StorageWorks 8000 - NAS Overview page 39

5. Verify Array Configuration
To ensure that your storage array(s) have been configured correctly, you must verify the array
settings on all arrays attached to your NAS 8000 system.
1. Connect a laptop with terminal emulation software to the array.
Connect an RS232 null-modem cable to one of the serial ports on the array.
Figure 12 Array Serial Ports
2. Use a terminal emulator to log in and confirm the array settings. Use the following settings:
— Bits per second: 9600
— Data bits: 8
— Parity: None
— Stop bits: 1
— Flow control: None
3. Press Enter until you see the command prompt. Then execute:
vfpmgr –os linux –c 1
vfpmgr –os linux –c 2
4. Determine whether the array is connected directly to the NAS server or using a FC switch:
— If you have one array connected to each NAS server, the array is connected directly to
the NAS server. Execute:
vfpmgr –t 1 –c 1
vfpmgr –t 1 -c 2
— If you have two arrays connected to each NAS server, the arrays are connected to a FC
switch. Execute:
vfpmgr –t 4 –c 1
vfpmgr –t 4 -c 2
Repeat these steps for each array on your NAS 8000 system.
Installation Guide 39