Replacing The Lamp - Epson EMP 8100NL Owner's Manual

Replacing the lamp

Replace the lamp at the following times (model number: ELPLP11).
When a message stating [Lamp Replace] is displayed for thirty seconds after
the start of projection
When the lamp indicator is blinking in orange
When the brightness and picture quality has deteriorated below the initial
levels
Point
· Replace the lamp when it will not light up even if it is not time for replacement.
· Replace the lamp as quickly as possible after the message has been displayed to main-
tain the initial brightness levels and picture quality.
· The replacement message has been set at approximately 2,000 hours of use in order to
maintain the initial brightness levels and picture quality.
· Although the replacement message is displayed after approximately 2,000 of use, there
are cases where the individual characteristics of each lamp and other usage conditions
result in it not lighting up before this 2,000 hours has elapsed. For this reason, always pre-
pare a replacement lamp well in advance.
· Replacement lamps are available from Epson OA Supplies Inc.
· Order your lamps from your nearest Epson dealer.
92 - Replacing the lamp
Lamp Replace
The lamp indicator will blink in orange.