Epson EMP 810 Network Installation Manual page 14

Confirm Your Network Settings
1. When you see a screen like this one, verify that the settings are correct. If you
need to change a setting, press
change.
2. Once you have verified that your network settings are correct, press
the settings and return to the Network Settings menu.
3. Press the
4. Wait for the printer to connect to your wireless network (this can take up to
90 seconds).
Once it's connected, you see the
on the printer's control panel.
5. Continue with "Install Software" on page 22.
Note:
If the printer doesn't connect to your wireless network after 90 seconds, the SSID,
WEP key, or WPA passphrase may have been entered incorrectly. See "Connect
Wirelessly Using Advanced Setup" on page 8 to select your network settings again.
If the printer still doesn't connect to your wireless network, see "The printer cannot
find or connect to the wireless router or access point" on page 29.
14
Wireless Network Installation
button to exit the Network Settings menu.
Home
until you see the setting you need to
Back
y
WiFi icon and a signal strength indicator
Wireless connection
established
to save
OK