Starting The Projector With A Password - Epson PowerLite 7900p User Manual

note
If you lose the remote
control, you will not be able
to enter the password, so
keep the remote control in a
safe place at all times.
note
When the period defined in
the setting
Time-elapsed
has passed, and the password
is entered correctly, the
elapsed time will be reset to
and the countdown will
0
start again. Remember to
disable or change this setting
when you need to.
Fine-tuning the Projector
82
6. Press to close the Password Protect menu.
Menu
7. Turn off the projector and unplug the power cord to enable
password protection.
When you turn the projector on again, you will need to enter a
password. Follow the instructions in the next section.

Starting the Projector with a Password

When the password function is enabled, you see this screen when you
turn on the projector:
Enter the password.
#Refer to the "User's Guide" for the operation.
[0-9]:Enter [0-9]:Enter
Press down the button on the remote control as you use the
Num
numeric keypad buttons to enter the password. Once you have
entered the password correctly, the password screen closes, and
projection begins.
If the password is not correct, you see the message
If you enter an incorrect password three times in
Please try again.
succession, you see the message
locked. Request code xxxxx
mode for approximately 5 minutes. Write down the request code.
Then disconnect the projector's power cord from the electrical outlet,
reconnect it, and turn the projector back on.
When you see the Password Protect Release screen again, you can try
to enter the correct password.
Password
Wrong password.
The projector's operation will be
and the projector switches to standby