How To Stop The Engine; How To Start The Engine - Craftsman 536.772340 Operator's Manual

OPERATION
HOW TO STOP THE ENGINE
1. To stop the engine, move the clutch lever
all the way back to the DISENGAGED
position.
2. Then, move the throttle control lever to
the STOP position (Figure 13).
9. Quickly pull the recoil starter handle. DO
NOT allow the starter rope to snap back.
Let the starter rope slowly rewind. If en-
gine fails to start after three pulls, push
primer button two times and again pull
the recoil starter handle.
HOW TO START THE ENGINE
IMPORTANT: Before you start the engine,
operate the controls several times. Make
sure all controls move freely.
1. Check the oil.
2. Fill the fuel tank with regular unleaded
gasoline. Make sure the gasoline is
clean. Leaded gasoline will increase de-
posits and shorten the life of the valves.
NOTE: Do not use gasohol or methanol. Do
not use premium unleaded gasoline.
,_ WARNING: Always use a safety
gasoline container. Do not
smoke when adding gasoline to
the fuel tank. When inside an enclosure,
do not add gasoline. Before you add
gasoline, stop the engine and let the en-
gine cool for several minutes.
3. Make sure the spark plug wire is con-
nected to the spark plug.
4. Pull the clutch lever all the way back to
raise and disengage the blade.
5. Move the throttle control lever (if
equipped) to the FAST position
(Figure 13).
6. Move the choke control lever to the
CHOKE position (Figure 13).
7. To start engine, hold the recoil starter
handle firmly with your right hand.
8. Hold the edger handle firmly with your left
hand.
Choke
Figure 13
10.When the engine starts, move the throttle
control lever up (FAST position) to in-
crease speed or down to decrease
speed. During normal use keep the
throttle in the FAST position.
11. If the engine does not start in 5 or 6 tries,
See the "Problem and Repair" Instruc-
tions.
NOTE: The cutting blade speed is con-
trolled by the engine speed. To reduce the
cutting blade speed, push down on the
throttle control lever. To increase the cut-
ting blade speed, pull up on the throttle
control lever.
,_ WARNING: Never run the engine
indoors or in a poorly ventilated
area. Engine exhaust contains
carbon monoxide, an odorless and
deadly gas. Keep hands, feet, hair and
loose clothing away from any moving
parts. Avoid the muffler and surround-
ing areas. Temperatures can exceed 150
degrees.
F-021102L 14