Special Notes For Bevel Set-Up; Making Rip Cuts - Craftsman 113.196380 Owner's Manual

8. Remove workpiece from table.
9. Ready push stick or push block.
10. Set up table extension(s) and support
their outer ends. Do not use another person
to support workpieces because this can
cause kickback and it exposes helper to
polential hazards at outfeed side.
Special Notes for Bevel Set-Up
,_ CAUTION
Bevel ripping creates unique prob-
lems of visibility and feeding.
Before cutting, check the set-up
using both in-rip and out-rip. Use
the position that gives the best
combination of workpiece visibility
and push stick clearance.
,_WARNING
Bevel the edge that is not against
the fence.
1. When setting bevel angle, raise radial arm
to allow sufficient clearance for blade and
guard to not jam in table.
2. When blade is beveled manually raise
clear plastic guard before lowering blade to
table or keff, otherwise it may jam in the
table.
3. "Io set hold down, place workpiece direct-
ly under guard nose, rather than parallel to
blade.
4. To set pawls, place workpiece directly
under set of pawls closer to table. This set of
pawls will keep contact with workpiece sur-
face.
Making Rip Cuts
Follow these steps to make in-rip cuts. For
out-rip cuts, reverse hand functions; that is,
put right hand on table and use left hand to
support and push workpiece.
t. Follow ripping set-up procedure.
In-ripping
Ripping
55