Changing The Batteries - Craftsman 315.212380 Operator's Manual

CHANGING THE BATTERIES
See Figure 52,
[] Unplug the saw.
[] Rotate and hold lower blade guard up.
[] Using the hex key (1/16 in.) provided, loosen the screw
then separate the cover from the laser guide.
[] Lower the blade guard.
[] Remove the three button cell batteries.
NOTE: Replace the batteries with button cell batteries
that have a rating of 1.5 volt and 100 mAh (milliampere
hour) minimum (number 76 series or equivalent).
When replacing the batteries, the laser guide should be
thoroughly cleaned. Use a soft paintbrush, or similar
device, to remove all sawdust and debris.
[] After cleaning the laser guide and replacing batteries,
secure battery cover to laser guide using the screw.
Tighten screw securely.
_ CAUTION: Use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous radiation
exposu re.
RESS
BATTERIES
BATTERY
COVER
SCREW
BATTERY
COVER
LASER
GUIDE
Fig. 52
36