Craftsman 315.212380 Operator's Manual page 32

Bevel
Angle
Setting
33.85 °
33.85 °
33.85 °
33.85 °
Type of Cut
Left side, inside corner
1. Top edge of molding against fence
2. Miter table set right 31.62 °
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62 °
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
2. Miter table set left 31.62 °
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
2. Miter table set right 31.62 °
3. Save right end of cut
CUTTING WARPED MATERIAL
See Figures 44 - 45.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side
against the fence as shown in figure 43.
If the warped material is positioned the wrong way
as shown in figure 44, it will pinch the blade near the
completion of the cut.
A
WRONG Fig. 45
WARNING: To avoid a kickback and to avoid
serious personal injury, never position the concave
edge of bowed or warped material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 46.
When cutting wide workpieces such as a 2 in. x 6 in.,
boards should be clamped with a C-clamp as shown in
figure 46.
WiDE
BOARD
RIGHT
Fig. 44
Fig. 46
32