Mounting Holes - Craftsman 315.212380 Operator's Manual

TO MOUNT MITER SAW
See Figure 12.
• Insert the supplied 3/8 in. machine bolts through the
holes in the miter saw base. Each of the four mounting
holes should be bolted through the miter saw base
securely using supplied 3/8 in. machine bolts, lock
washers, and hex nuts as shown in figure 12.
• Tighten all four bolts securely.
HEXBOLT MOUNTING
HOLES
LOCK
WASHER
MOUNTING HOLES
See Figure 13.
If not mounted to the supplied Stand-n-Stow
TM
cabinet,
then the compound miter saw should be permanently
mounted to a firm supporting surface such as a
workbench. Four bolt holes have been provided in the saw
base for this purpose. Each of the four mounting holes
should be bolted securely using 3/8 in. machine bolts,
lock washers, and hex nuts (not included). Bolts should be
of sufficient length to accommodate the saw base, lock
washers, hex nuts, and the thickness of the workbench.
Tighten all four bolts securely.
The hole pattern for mounting to a workbench is shown in
figure 13. Carefully check the workbench after mounting
to make sure that no movement can occur during use.
If any tipping, sliding, or walking is noted, secure the
workbench to the floor before operating.
TRACEHOLESATTHESE
LOCATIONS FORHOLEPATTERN
WASHER
MITER WASHER HEXNUT
SAW BASE Fig. 12
BASE
MOUNTINGSURFACE
Fig. 13
17