Installing Blade Guard - Craftsman 113.221611 Owner's Manual

INSTALLING BLADE GUARD
1. From among the loose parts, find the hardware as
shown
SQUARE NUT
_....._ , _..,_F SPREADER St'IPPORT
TRUSS HEAD _ _ SPREADER BRACKET
SCREW _ _ J"
5/8 IN LONG "_,_(7"_ K-_}_-"_'_.,. , _ SPREADER CLAMP
1 /
SOCKET HEAD _
SETSCREW _,_-_,_1_ "-_ (J'-- I WING NUT
718 , ., Lo.a
g "IL_&j
/
FLAT WASHER/_)
@'_.
HEX NUT -"-'_'_ LOCKWASHER
EXT, 1/4 IN.
BLADE SQUARE
WITH TABLE
2 MAKE SURE THE BLADE IS ALL THE WAY UP
AND SQUARE WITH THE TABLE
3, Position SPREADER SUPPORT on rod until it is
even with the end of the rod
SPREADER SUPPORT
EVEN WITH ROD
4. Assemble the 7/8 in, long setscrews, nuts,
Iockwashers and washers to the SPREADER
SUPPORT BRACKET and slip the nuts into the
slot in the spreader support
5 Finger tighten ONLY THE HEX NUTS
16