Epson USN 52R Operating Manual page 100

Data set names
The additional information is now stored together with
the data set number. If the MEMO function was used
for the selected data set, you will see the first 46 char-
acters of the entered additional information instead of
the menu bar in the PREVIEW mode (the first operating
level).
Krautkramer USN 52R/USN 52L
Filling in a data header
In the two lower lines you will see letters, numbers and
characters that you can use for the texts.
Above it, you will see four other lines: two lines contain-
ing the labelings of the selectable fields, each of the
lines below them are used for text entries. Depending
on the data header configuration, some fields are al-
ready automatically filled in with data from the currently
active A-scan. You cannot select these fields.
To enter the required text, start by selecting a field and
then the entry position in each case, and continue by
selecting the character to be inserted at that position.
The entry position and character are always marked by
a flashing cursor. You can enter all required characters
in any chosen order.
Operation:
– Press the keys N or O next to the corresponding
character string in order to select a character. The
flashing cursor changes the string automatically. The
highlighted character is immediately inserted at the
entry position.
– Press the keys T or V to change the entry
position within a field.
Issue 05, 02/00
Operation
5-55