Assen_Ly And Alignment; Assembling Stand - Craftsman Contactor 113.236400 Owner's Manual

unpacking and checking contents
WARNING: For your own safety, never connect
plug to power source outlet until all assembly
steps are complete, and you have read and under-
stand the safety and operating instructions.
WARNING: This saw is heavy. To avoid back
Injury, or Injury from falling saw, get help when-
ever you have to Uft or move the saw.
assembly and alignment .............................
ASSEMBLING STAND _
1. Fromthe loose parts bag, find the following hardware: M 8x !6
Separate all parts from packaging materials and check
each item with illustration and "Table of Loose Parts".
Make certain all items are accounted for before discard-
ing any packaging material.
I WARNING: To avoid injury, if any parts are miss-
Ing, do not attempt to assemble the Scroll Saw,
plug in the power cord, or turn the switch 'ON'
until the missing parts are obtained and Installed
corre 'ti,y., . ............
,ll
©
M8 HEX NUT
* Hex Head Bolt, M8 x 16 .................................... 32
* Lockwasher M8 ................................................ 32
* Hex Nut M8 ....................................................... 32
* Grommet ............................................................. 2
" Hex Nut 3/8-16 ................................................... 8
Leveling Foot ...................................................... 4
* Indicates item is shown actual size.
HEX HEAD BOL I- M8 LOCKWASHER
O
GROMMET
HEX NUT3/8-16 LEVEUNG FOOT
2. From the loose parts, find the following items:
A Stand Top .......................................................... 1
B Front Leg, Right ................................................. 1
C Front Leg, Left ................................................... 1
D Rear Leg, Right ................................................. 1
E Rear Leg, Left .................................................... 1
F Front Stiffener .................................................... 1
G Rear Stiffener .................................................... 1
H Side Stiffener ..................................................... 2
3. Assemble the stand as follows.
4. Laythe standtop upside downon the floor. Attachthe
legs to the inside.ol the top as shown. Use four (4)
bolts, nuts and Iockwashers for each leg. Hand
tighten the hex nuts.
5. Attach the front, rear, and two side stiffeners to the
legs. Two (2) bo_s, nuts and lockwashers are used at,
each end of the stiffeners to attach them to the legs.
Hand tighten the hex nut.
6. Install one 3/8-16 hex nut on each leveling foot and
place through hole in the bottom of each leg, as
shown. Install second 3/8,16 hex nut on each foot
and tighten all nuts securely with a 9/16" wrench.
CAUTION: Use the leveling feet for leveling only.
Do not use for height adjustment. Extend each
foot only far enough to level the Stand.
7: Set stand in an upright position, With stand resting
level on floor, fighten al! hardware with 13mm wrenches
or sockets.
®