Table of Contents
Advertisement
Remove the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to cart left side
panel with the nut, shown A.
Insert AA battery into ignition module, negative (=) end first. Then put on the cap, shown B.
Untie the 7 burner ignition wires bundled under the right side of grill head. Draw the wires over the cart partition panel.
Connect each of the ignition wires from the main burner electrodes and sideburner electrode into the back of the Electronic
Ignition Module. Total (7) connections.
Untie the two wires [(a) and (b)] from under the left side of grill head. Connect the two wires [(a) and (b)] from the switch
wiring harness into the back of the Electronic Ignition Module. Total (2) connections.
NOTE: Switchterminals
are larger than electrode terminals and should only be installed in locations shown as (a),(b).
Use one of the bundling ties to bundle the 9 wires together, and tie to the gas line hose so that the wires don't
hang down into the cabinet.
!
Nut
Heat field
Insert front brace under control panel and between cart side panels. Secure using two 114-20x13/4 '' screws, 7ram lock
washers and 7ram flat washers on each side, shown A.
Under front brace, secure cart partition panel to front brace using one #8-3/8" tapping screw, shown B.
7ramLockwasher
#8-3/8"tapping screw
Qty.4
Qty.1
©
7ramflat washer
Qty.4
1/4-20x13A"screw
Qty.4
464224010.19
Advertisement
Table of Contents
