Table of Contents
Advertisement
Turn controls and gas source or tank OFF when not
in use.
CAUTION
if ignition does NOT occur in 5 seconds, turn the
burner controls
OFF, wait 5 minutes and repeat the
lighting procedure, if the burner does not ignite with
the valve open, gas will continue
to flow out of the
burner and could accidently
ignite with risk of injury.
Match-Lighting
A Do not lean over grill while lighting.
1. Open lid. Turn on gas at LP cylinder.
2. Place lit match into match holder (hanging from cart side
panel), then into lighting hole on right or left side of grill.
3. Push in and turn far right or far left burner knob to HIGH _.
Be sure burner lights and stays lit.
4. Light adjacent burners in sequence by pushing knobs in and
turning to HIGH _.
Sideburner
Ignitor Lighting
A Do not lean over grill while lighting.
1. Open sideburner lid. Turn on gas at LP cylinder.
2. Turn sideburner knob to HIGH (_, push and hold
ELECTRONIC IGNITOR button.
3. if sideburner does NOT light, turn knob to OFF (_, wait 5
minutes, then repeat lighting procedure.
Sideburner
Match Lighting
1. Open sideburner lid. Turn on gas at LP cylinder.
2. Place lit match near burner.
3. Turn sidebumer knob to HIGH (_.
Be sure burner lights and
stays lit.
8 , 463268107
Burner Flame Check
, Remove cooking grates and flame tamers. Light burners, rotate
knobs from HIGH _) to LOW (_. You should see a smaller
flame in LOW position than seen on HIGH. Perform burner
flame check on sidebumer, also. Always check flame prior to
each use. If only low flame is seen refer to "Sudden drop or low
flame" in the Troubleshooting Section.
Turning Grill Off
, Turn all knobs to OFF (_ position. Turn LP cylinder off by
turning hand-wheel clockwise to a full stop.
Ignitor Check
• Turn gas off at LP cylinder. Press and hold electronic ignitor
button. "Click" should be heard and spark seen each time
between collector box or burner and electrode. See
"Troubleshooting" if no click or spark.
Valve Check
_mportant: Make sure gas is off at LP cylinder before
checking valves. Knobs lock in OFF position. To check
valves, first push in knobs and release, knobs should spring
back. if knobs do not spring back, replace valve assembly
before using grill. Turn knobs to LOW position then turn back to
OFF position. Valves should turn smoothly.
Hose Check
• Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using grill. Use only
valve/hose/regulator specified by manufacturer.
General Grill Cleaning
, Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory (and should never be painted). Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush
on insides of grill lid and bottom. Rinse and allow to completely
air dry. Do not apply a caustic grillloven cleaner to painted
surfaces.
, Plastic parts: Wash with warm soapy water and wipe dry.
A Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic parts. Damage to and
failure of parts can result.
• Porcelain surfaces: Because of glass-like composition, most
residue can be wiped away with baking soda/water solution or
specially formulated cleaner. Use nonabrasive scouring powder
for stubborn stains.
• Painted surfaces: Wash with mild detergent or nonabrasive
cleaner and warm soapy water. Wipe dry with a soft
nonabrasive cloth.
• Stainless steel surfaces: To maintain your grill's high quality
appearance, wash with mild detergent and warm soapy water
and wipe dry with a soft cloth after each use. Baked-on grease
deposits may require the use of an abrasive plastic cleaning
pad. Use only in direction of brushed finish to avoid damage.
Do not use abrasive pad on areas with graphics.
Advertisement
Table of Contents
