Table of Contents
Advertisement
16. Firmlyattachignitor wirefrom sideburnerto front of valve.
See Fig. 7a. Beneath left shelf, insert sidebumer valve into
sideburner tube. See Fig. 7 for proper engagement.
Attach sideburnervalve to shelf using 2 of the M4xl0
Phillips-headscrews and washers. Place knob seat, spring,
and sideburner knob over valve stem.
FIGURE 7
-Spring
wire
17, Secure grillhead to all cart legs using 4 of the 1/4x2.112"
Phillips-headscrews and 1/4" nuts. See Fig. 8.
18. Fully tighten all leg screws, rear panel screws, door
bracket screws, and grill head screws.
19. From the back of the cart, slide the greasedraining tray into
the grill head. Place the grease receptacle into the notches
on the bottom ofthe tray.See Fig. 8.
FIGURE 8
Grease
draining
receptacle
Attach grill head
to ell 4 legs
20, Place your LP gas tank (not included ontothe poll-outtank
tray and push tray into cart. Be sure the tank valve is facing
forward. See. Fig. 9. READ USE & CARE SECTION
BEFORE A'FI'ACHINGREGULATOR TO LP TANK.
FIGURE 9
LPgas
tank
21. Unscrew the ignitor cap located on the control paneland
remove the contact and spring from the ignitorslot.
See Fig. 10.
22. Placethe suppliedAA batteryintothe ignitor slot withthe
positive pole facing toward you.
23, Placethe spring withcontact over the battery. Screw the
ignitor cap back onto the control panel,
FIGURE 10
ing
Contact,
Ignitor_
_.
cap
_
AA
24. Attachpanel to front of sideburner s helfby placing top lip of
panelABOVE bottom lip of shelf. Secure usingthree
3/16"x3/8" Phillips-head screws and 3/16" nuts. Fully
Tighten,See Fig. 11.
FIGURE 11
lip
8 • 4632215
Advertisement
Table of Contents
