Printer Problems - Epson Stylus Photo 960 Basic Manual

Printer Problems

Only the green P power light is
on, but nothing prints.
Make sure the interface cable is
securely connected at both ends
and meets the system
requirements; see page 87.
Run a printer check as described
on page 76. If the test page
prints, make sure your software
is installed correctly.
If you're printing on a network,
make sure you set up your
printer for network printing, as
described in your on-screen
Reference Guide in the EPSON
Printer Information Center.
The printer sounds as though it is
printing, but nothing prints.
The print head nozzles may
need cleaning; see page 57 for
instructions.
The printer won't operate
properly if it's tilted or at an
angle. Place it on a flat, stable
surface.
Your printer makes noise when
you turn it on or after it has been
sitting for awhile.
Your printer is performing routine
maintenance.
78
Solving Problems
Printing is too slow.
Make sure your system meets the
requirements listed on page 87. If
you're printing a high-resolution
image, you need more than the
minimum requirements. You may
also need to:
Clear space on your hard drive
or run a defragmentation utility.
Close open programs that
you're not using.
Increase your system's memory
(RAM).
For the fastest printing, try these
tips:
Select as the Quality Type
Draft
(Windows) or set the
Quality/Speed slider to
(Macintosh).
In the Advanced window, turn
®
MicroWeave
only) and/or turn
on.
If your printer is connected to a
USB hub, disconnect any
unused USB devices.
If you're using the parallel port,
enable ECP/DMA mode on
your computer's parallel port.
See your computer
documentation or the
manufacturer for instructions.
Speed
off (Macintosh
High Speed