Table of Contents
Advertisement
TROUBLESHOOTING
GUIDE
If you have followed
the instructions
contained
in this manual
and have difficulty
in operating
your TV/VCR,
locate the SYMPTOM
in the left column below. Check the corresponding
POSSIBLE
CAUSE
and CORRECTIVE
ACTION
columns
to remedy the problem.
SYMPTOM
POSSIBLE
CAUSE
CORRECTIVE
ACTION
No power.
•
AC Power cord is not connected.
Connect
AC power cord to AC outlet.
•
Power is off.
Press POWER
button to turn on the
TV/VCR.
No picture
and sound.
Plug power
cord into an active AC outlet.
Check
antenna
connection.
Program
tuner's
memory.
Adjust direction
or replace
antenna.
TV/VCR is not plugged into an active
AC outlet.
Antenna is not connected.
No channel in memory.
Direction or condition of antenna is not
adequate.
Picture control is not adequate.
Volume control on remote control unit
or main unit is in minimum position.
MUTE button on the remote control
unit is in the ON position.
The timer recording is set incorrectly.
The timer recording is not set to ON.
The erase-prevention
tab on cassette is
missing.
The TRACKING control is not set
correctly.
Video heads are dirty.
No picture or poor picture
on TV/VCR.
Adjust picture controls.
No sound or poor sound.
Adjust volume control on remote control
unit or set.
Press MUTE button.
Timer recording is not
Set the timer recording correctly.
possible.
Set the timer recording to ON.
Cannot go into Record
Place transparent tape over missing erase-
mode.
prevention tab.
Playback picture is
Adjust TRACKING control for better
partially noisy,
picture.
Noise in picture on
Head cleaning is necessary, consult the
playback,
nearest Sears Service Center.
No operation by infrared
• No power to TV/VCR.
Make sure the AC cord is connected to an
Remote Control.
AC outlet.
• Weak batteries.
Check the batteries in the Remote Control.
- 32 -
EN
*****
5C23
Advertisement
Table of Contents
