Table of Contents
Advertisement
TO CORRECT
A PROGRAM
• While
setting a program;
Press VOLUME
"v" but-
ton on the TV/VCR
to go back one step, and enter
corrected
digit.
• After
setting
a program;
repeat
steps
[2] and
press
SELECT
button
repeatedly
(or press DE-
LETE
button
to go back one step) until your de-
sired digit flashes
and re-set program.
TO CANCEL
A QUICK
SET PRO-
GRAM
• While setting or after setting a program;
1) press
POWER
button.
2) press MONITOR
button,
then,
press VOLUME
"v" button.
• While
recording
is in progress;
1) press MONI-
TOR button.
2) press STOP/EJECT
button on the
TV/VCR.
If you press POWER
button
to turn off
before the end time, timer recording will continue.
WHEN THE PROGRAMS
OVERLAP
Quick Set Program has priority. However, if another
program has been activated before the start of the Quick
Set Program, the Quick Set Program will begin after the
other program has finished.
If you programmed as per the illustration the timer re-
cording would be carried out as follows:
I
[
1
PROGRAM
2
I
I
E
I
I
I
9:00PM
IO:OOPM
•
11:00PM
12:00AM
9:00PM - 11:00PM
11:00PM - 12:00AM
12:00AM -
for PROGRAM
1
for PROGRAM 8
(Quick Set Program)
for PROGRAM 2
• Makc sure tile channcl you want to rccord is properly
set in advance.
• It is not necessary to press RECORD button for
timer recording.
• Recording begins automatically at the set ofthe Start
time.
• If you are recording using a Timer mode, you may
not operate the unit manually.
• The erase-prevention tab on the cassette must be in
place (or you must put tape over the hole).
• If the erasure protection tab is removed, the cassette
will be ejected when the POWER button is pressed
to off, and the TIMER REC indicator flashes.
• If the POWER button is pressed to off with no cas-
sette loaded, the TIMER REC indicator flashes.
• If the TIMER REC indicator flashes, insert a tape
with the erase-prevention
tab intact. The TIMER
REC indicator will illuminate.
• If the tape runs out before the end time, the TV/VCR
will switch to the Stop mode immediately, and the
tape will be ejected.
• If there is a power failure or if the TV/VCR is un-
plugged for more than a few seconds, the clock and
timer settings will be lost. At this time, the TV/VCR
screen will automatically return to the Clock Set
mode when you choose the Program Set mode.
TO CHECK
THE
START/END
TIME
1) Press POWER button so that the TIMER REC indi-
cator goes off.
2) Press MENU button on the remote control.
3) Select item l (TIMER PROGRAMMING)
using
number 1 button.
4) Enter your desired program number using number
button. The details of selected program appears on
the TV/VCR screen.
5) Press MENU button. The TV/VCR screen returns to
the TV mode.
- 29 -
EN
-_ _ ¢r'l__ 5D05
Advertisement
Table of Contents
