Table of Contents
Advertisement
Recording
Continued
I_
IMPORTANT:
• It should be noted that it may be unlawful to re-record
pre-recorded tapes, records, or discs without the
consent of the owner of copyright in the sound or video
recording, broadcast or cable programme and in any
literary, dramatic, musical, or artistic embodied
therein.
• The recording level is automatically set correctly, so it is
not affected by the VOLUME, the SUBWOOFER LEVEL,
and the SOUND MODE controls. Thus, during recording
you can adjust the sound you are actually listening to
without affecting the recording level.
• If there are excessive noise or static in the recording you
have made, the unit may be too close to a TV. Increase the
distance between the TV and the unit.
• You can use type I tape for recording.
To protectyour recording
Cassettes have two small tabs
on the back to protect from
unexpected erasure or re-
recording.
To protect your recording,
remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
To keepthe best recordingand playbacksound
quality
If the heads, capstans, and pinch rollers of the cassette deck
become dirty, the following will occur:
• Impaired sound quality
• Discontinuous sound
• Fading
• Incomplete erasure
• Difficulty in recording
To clean the heads, capstans, and pinch rollers
Use a cotton swab moistened with alcohol.
--
Pinch rollers --
Capstans
Recordingon a Tape
1 Press _
EJECT
to insert
a recordable
cassette
with the exposed
part of the tape down.
2
Close the cassette holder gently.
• If you want to record on both sides of a tape, see "To
record on both sides--Reverse
Mode."
3
Check
the tape
direction
of the cassette
deck.
• If the tape direction is not correct, press TAPE < _ twice
then • to change the tape direction.
4
Start playing
the source--FM,
AM, CD player,
or auxiliary
equipment
connected
to AUX jacks.
• When the source is CD, you can also use CD Direct
Recording--(see
page 23), and Auto Edit Recording-
(see page 24).
5
Start recording.
On the unit:
Press REC START/STOP.
REC
START
I STOP
%
On the remote control:
Press
and hold REC START/STOP
for more than
1 second.
The REC (recording) lamp flashes when recording starts and
the tape direction indicator (_ or <) starts flashing slowly.
• If no cassette is inserted, "NO TAPE" appears on the
display. If a protected tape is inserted, "NO REC"
appears on the display.
To stop recording
immediately,
press REC START/STOP
or •
(or press and hold REC
START/STOP
on the remote
control
for more than 1 second).
To remove the cassette,
press & EJECT to open the cassette
holder.
Heads
To demagnetize
the heads
Turn off the unit, and use a head demagnetizer
(available
at
electronics
and audio shops).
To recordon bothsides--Reverse Mode
On the unit ONLY:
Press REVERSE MODE so that the Reverse Mode ..... ,,oo_S_
indicator on the display lights up like--('_).
• When using the Reverse Mode for recording,
start recording in the forward (_) direction first.
Otherwise, recording will stop when recording is
done only on one side (reverse) of the tape.
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator on the display lights up like--__.
- 22 -
Advertisement
Table of Contents
