Table of Contents
Advertisement
Listeningto FM andAM Broadcasts
Tuning in to a Station
1
Press FM/AM.
The unit automatically turns on and tunes
in to the previously tuned station (either
FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
/AM
2 Start searching
for stations.
On the unit:
Press and hold TUNING
+
or TUNING
- for more
than 1 second.
...........
T, JNI_I .......... "t"
On the remote control:
Press
and hold _
(_)
or _<
(<<)
for more
c-x..
than
1 second.
_)_
The unit starts searching for
stations and stops when a station of sufficient signal
strength is tuned in.
• Ifa program is broadcast in stereo, the ST (stereo) indicator
lights up.
To stop searching, press TUNING + or TUNING - (or
_t
(t,q_) / _
(<1_) on the remote control).
When you press TUNING + or TUNING - (or _
(IH_) /
_<
(<1.4) on the remote control) briefly and repeatedly
The frequency changes step by step.
On the unit ONLY:
1 Tune in to the station
you want to preset.
• See "Tuning in to a Station."
2 Press SET/DISPLAY.
SET/
DISPLAY
%
3
Turn PRESET + / - to select a
preset number.
4 Press SET/DISPLAY
again.
SET/
DISPLAY
•, %
D.-_.l
T m
_, ,_,F'r _,,
The tuned station in step 1 is stored in the preset number
selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
_f
hen you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
To changethe FM receptionmode
On the remote control
ONLY:
When an FM stereo broadcast is hard to receive
FMMODE
or noisy, press FM MODE so that the MONO
indicator lights up on the display. Reception
improves.
To restore the stereo effect, press FM MODE again so that
the MONO indicator goes off. In this stereo mode, you can
hear stereo sounds when a program is broadcasted.
Presetting Stations
You can preset 30 FM and 15 AM stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 2 again.
Tuning in to a Preset Station
1
Press FM/AM.
The unit automatically turns on and tunes
in to the previously tuned station (either
FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
/AM
2 Select a preset number.
On the unit:
Turn PRESET + / -.
On the remote control:
Press
the number
buttons.
Ex.: For preset number 5, press 5.
Q
For preset number 15, press
+ 10, then 5.
For preset number 25, press
+10, +10, then 5.
For preset number 30, press
+10, +10, then 10.
QQ
QQ
OO
®%.
-13-
Advertisement
Table of Contents
