Connecting Speakers - JVC CA-HXZ1 Instructions Manual

Continued II_
AM antenna
1
Connecting Speakers
O
-ANTENNA
m
AM LOOP
m
FM 75
-COAXIAL
inyl-covered wire
ot supplied)
AM loop antenna
(supplied)
2
3
If cords are covered with insulation, twist the
core of the cord at the end of each cord, then
remove the insulation.
Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
Turn the AM loop antenna until you have the
best reception.
To connectan outdoorAM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
_For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other terminals
and connecting cords.
• Keep the antennas away from metallic parts of the unit, connecting
cords, and the AC power cord.
2
1
Speaker cords
(black/blue
Speaker cords
m I rm
Speaker cords
(black/red)
From right
subwoofer
From left
subwoofer
From main
right speaker
From main
left speaker
If cords are covered with insulation, twist the
core of the cord at the end of each cord, then
remove the insulation.
Insert the end of the speaker cord into the
terminal as illustrated.
Match the same polarity: (+) to (+) and (-) to (-).
3
Close the speaker terminals.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
DO NOT connect more than one speaker to each
speaker terminal.
DO NOT push or pull the speakers as this will
damage the foot spacers at the bottom of the
speakers.
-8-