Using The Cassette Deck (Recording); Things To Know Before You Start Recording - JVC CA-D5T Instructions Manual

=
. n
DB
bond
we
REC START/STOP
Things To Know Before You Start Recording
[3 Two small tabs on the back of the cassette tape, one for
side A and one for side B, can be removed to prevent
accidental erasure or re-recording.
To record on a cassette with the tabs removed, you must
cover the holes with adhesive tape first. However, when a
type II tape is used, only cover part of the hole as shown,
since the other part of the hole is used to detect the tape
type.
(2 When recording, you can hear Sound Effect effects through the speakers or headphones.
However, the sound is recorded without Sound Mode effects.
(1 Type I and Type II tapes can be used for recording.
Note: At the start and end of cassette tapes, there is leader tape which cannot be recorded onto.
Depending on the recording source, the first part of the recording may be missing because of the
leader. When recording CDs or radio broadcasts, to get the beginning of the recording on the tape,
first wind on the leader before beginning recording.
CAUTION: If recordings you have made have excessive noise or static, the Unit may be too close to
a TV which was on during the recording. Either tum off the TV or increase the distance between the
TV and the CA-D5T.
23