Power - JVC GR-D350U Instructions Manual

HowToAttach TheLens Cap
To protect the lens, attach
the provided lens cap to the
camcorder as shown in the
illustration.
NOTE:
To confirm the lens cap is on
correctly make sure the cap is
flush to the camcorder.
,&
GETTINGSTARTED
EN 1 1
II Power
This camcorder's 2-way power supply system
lets you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging T heBatteryPack
Battery pack mount
Bakery pack
PUSH
BATT.
Place
shooting.
HowToAttach TheShoulder Strap
Follow the illustration.
1 Thread the strap through the eyelet.
2 Fold it back and thread it through the strap
guide and the buckle.
• To adjust the length of the strap, loosen and then
tighten the strap in the buckle.
3 Slide the strap guide fully towards the eyelet.
Buckle
To DC connector
To AC outlet
POWER/
CHARGE
lamp
8
Strap guide
Eyelet
1
Set the Power Switch to "OFF".
2 With the arrow on the battery pack pointing
downward, push the battery pack slightly against
the battery pack mount (_).
3 Slide down the battery pack until it locks in
place (_).
4 Connect the AC Adapter to the camcorder.
5 Plug the AC Adapter into an AC outlet.The
POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
6 When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC Adapter
from the AC outlet. Disconnect the AC Adapter
from the camcorder.