Operation; Before First Use; Testing The Chip Warmer - Vulcan-Hart VCD22* ML-138037 Installation & Operation Manual

VCD SERIES CHIP WARMER

BEFORE FIRST USE

The Chip Warmer should be thoroughly
cleaned before initial use.
Always
electrical power to the Chip Warmer
before cleaning or servicing.
1. Remove Access
unlocking clips.
2. Place Access Panel away from
Chip Warmer.
3. Remove Top Door.
4. Remove all
through back opening.
5. Using a soft, clean cloth, clean
Top Door and Baffles with a
solution of mild detergent and
warm water.
cloth and warm water. Wipe dry
with a soft dry cloth.
Never spray the unit with a hose.
6. Using a soft, clean cloth, clean
the inside of the unit with a
solution of mild detergent and
warm water.
cloth and warm water. Wipe dry
with a soft dry cloth.
7. Replace Top Door and all internal
Baffles.
8. Reattach Access Panel.

OPERATION

disconnect
Panel by
internal Baffles
Rinse with a soft
Rinse with a soft

TESTING THE CHIP WARMER

parts are hot. Be very careful when
operating, cleaning, or servicing the
warmer.
Before using the Chip Warmer for the
first time, verify that it operates properly.
1. Verify that the Chip Warmer is
connected to the correct power
source.
2. The Lighted Power Switch is
located on the top rear of the
Chip Warmer.
switch to ON position. Verify that
the switch illuminates. (Fig. 5)
3. Check the interior rear of warmer
to ensure that it is heating. The
internal
preset to 180⁰ F. The blower fan
circulates heated air through the
perforated removable chip tray
located at the bottom of the
interior of the cabinet (under the
chips.)
6
F-38053 (02-13)
The Warmer and its
Switch power
(Fig.5)
thermostat is factory