Epson Stylus 1520 User Manual page 64

4. Move the center support to a point midway between the edge
guides. Then gently extend the rear edge guide until it stops.
5. Fan a stack of paper; then tap it on a flat surface to even the
edges.
6. Load the stack of paper, printable side down, all the way into
the sheet feeder. Make sure the right edge of the stack is
against the right edge guide. Next, slide the left edge guide
against the left edge of the paper.
Note:
The sheet feeder can hold up to 100 sheets of 17-lb or 64g/m
paper. Do not load paper above the arrow mark, which is located
on the inside surface of the edge guide.
3-4
Starting to Print with Windows
2
plain